It’s always better to use SSH not Telnet if you are connected from a remote location and someone may snoop your password.
You must enable SSH on the Cisco gear by using:
crypto key generate rsa
Tune timeout and re-tries:
ip ssh timeout 120
ip ssh authentication-retries 3
Look up if you have SSH enabled on your Cisco router:
show ip ssh
See the SSH status:
show ssh
Exit from boot menu. Continue with flow.
Preparing to decompress…
100%
Decompressing SW from flash
100%
OK
Running from RAM…
******************************************************************
*** Running SW Ver. 1.0.3 Date 29-Mar-2007 Time 10:49:18 ***
******************************************************************
HW version is 00.03.00
Base Mac address is: 00:1d:7e:7a:2a:81
Dram size is : 32M bytes
Dram first block size is : 17152K bytes
Dram first PTR is : 0xF40000
Flash size is: 8M
01-Jan-2000 01:01:05 %CDB-I-LOADCONFIG: Loading startup configuration.
Device configuration:
PCB revision: 1
Slot 1 – SRW2008 HW Rev. 0.1
Tapi Version: v1.3.3.1
Core Version: v1.3.3.1
01-Jan-2000 01:01:17 %OS-A-MEMORY: Main System Memory Pool Overflow
01-Jan-2000 01:01:17 %ERHG-E-SEND: return to the DEFAULT sizes of TABLEs
01-Jan-2000 01:01:17 %ERHG-E-SEND: RSP_INIT: Fatal Error
**************************************************
***************** SYSTEM RESET *****************
**************************************************
Some users may be getting the above error message with Linksys SRW2008 Gigabit switch.
To fix this error you should delete the config file. Hit the Escape key when the following is displayed on the switch console:
Autoboot in 2 seconds – press RETURN or Esc. to abort and enter prom.
when the system boots up and then Chose Delete File option. After enter the filename:
config
and hit enter. Reboot the switch and switch should be set to all defaults.
Recent Comments